Thanks HarveyC.
I found that directory and the settings saved in the ini files are what I have set in pronterface but pronterface is not reading those settings from the console.
If I open a file under plater and then save the gcode file and load that file all is good.
However if I load a file directly into pronterface and print, the print turns out with the parameters that were in the original downloaded slic3r and not my changed parameters. Eg. 200c and raise print head before printing.
It's not impossible to print this way, just annoying when it didn't happed before my crash..
I found that directory and the settings saved in the ini files are what I have set in pronterface but pronterface is not reading those settings from the console.
If I open a file under plater and then save the gcode file and load that file all is good.
However if I load a file directly into pronterface and print, the print turns out with the parameters that were in the original downloaded slic3r and not my changed parameters. Eg. 200c and raise print head before printing.
It's not impossible to print this way, just annoying when it didn't happed before my crash..