Re: Pronterface setting 200 deg default

Thanks for the reply.

I have changed the settings in sli3er to zero but it doesn't seem to be reading the settings.

The only way I can get a print is to generate the g code in sli3er and save and then load this g code or pause the print at the start and set the hot end to 230 and then continue.

I don't know why but pronterface doesn't seem to read the settings at startup.

I have saved the new settings as config in sli3er and this is where pronterface looks for the sli3er settings when I click on settings in pronterface so I don't know what else to do.