Only command at start of gcode is G28; home all axis.
Another reason I think pronterface is not reading sli3er is when I downloaded pronterface, it had a command at the start something like G1 Z5 S5000. This caused the print head to retract about 10mm until the temp reached 200 and then it would return to the table and start to print.
I removed this comment line and pronterface still does this command.
I'm wondering if pronterface is looking for another version of slic3r at another location.
If I go pronterface, settings, and use plater to generate a gcode, then load the gcode all is fine and the print behaves as saved but if I load a file and then print from pronterface gui, the print reverts to retract print head and print at 200c.
My C: drive folders are Pronteface\Slic3r\slic3r.exe.
When I enter pronterface settings, the command console states Entering slicer settings, Slic3r\slic3r.exe.
but I don't know where it is looking for that copy of gcode on my hard drive.
Curiouser and curiouser....
Another reason I think pronterface is not reading sli3er is when I downloaded pronterface, it had a command at the start something like G1 Z5 S5000. This caused the print head to retract about 10mm until the temp reached 200 and then it would return to the table and start to print.
I removed this comment line and pronterface still does this command.
I'm wondering if pronterface is looking for another version of slic3r at another location.
If I go pronterface, settings, and use plater to generate a gcode, then load the gcode all is fine and the print behaves as saved but if I load a file and then print from pronterface gui, the print reverts to retract print head and print at 200c.
My C: drive folders are Pronteface\Slic3r\slic3r.exe.
When I enter pronterface settings, the command console states Entering slicer settings, Slic3r\slic3r.exe.
but I don't know where it is looking for that copy of gcode on my hard drive.
Curiouser and curiouser....